Highlights • Similar primary zirconia properties by speed-sintering as conventional sintering. • Speed-sintering 3Y-TZP decreased its translucency but not that of 5Y-PSZ. • Speed-sintering lowered the mechanical reliability of 3Y-TZP…
Abstract Objective To investigate the clinical behavior of two different resin-based restorative systems in extended Class II cavities in a controlled prospective split-mouth study over 12 years and to assess…
Graphical abstract Highlights • Direct laser metal sintering (DLMS) 3D printing conditions were optimized for medical-grade Ti-6Al-4V powders. • The inner defect amount and mechanical properties varied depending on the…
Abstract Objective Agglomeration is a common problem facing the preparation and application of nanomaterials, and whether nano-hydroxyapatite (nano HA) can modulate oral microecology left to be unclear. In this study,…
Highlights • The composite filaments were successfully developed via melt-blending technique. • AMP-PEEK filaments can serve as feedstock for 3D printing of patient-specific implants. • The bioactivity of the composites…
Highlights • The clinical procedure to adhesively lute ceramic restorations is complex, by which a simplified application procedure is desirable. • Silane-coupling monomers degrade in water; hydrolysis is avoided when…
Abstract Objectives Tetrahydrofurfuryl-methacrylate (THFM) and hydroxypropyl-methacrylate (HPM) were used to partially or fully replace HEMA in experimental RMGICs. The experimental materials were compared with home and commercial products in terms…
Abstract Objective Water sorption, high volumetric shrinkage, polymerization stress, and potential estrogenic effects triggered by leached compounds are some of the major concerns related to BisGMA-TEGDMA co-monomer systems used in…
Abstract Narrow-diameter implants (NDIs) traditionally have been associated to higher rates of failure in comparison with regular-diameter implants (RDIs) and wide-diameter implants (WDIs), since they generate a more unfavorable stress…
Abstract Objectives The purpose of the study was to compare the mvM stresses occurring in inlays, onlays and endocrowns made from different materials and their bonding with molars in a…
