Graphical abstract Abstract Objective Maxillary sinus floor augmentation (MSFA) is commonly used to increase the alveolar bone height in the posterior maxilla before implant placement. In the present study, we…
Graphical abstract Highlights • Peel bond strength between 3D printed tray materials and elastomers was studied. • The tray materials showed good chemical compatibility with the elastomer adhesives. • 3D…
Graphical abstract Highlights • Direct laser metal sintering (DLMS) 3D printing conditions were optimized for medical-grade Ti-6Al-4V powders. • The inner defect amount and mechanical properties varied depending on the…
Abstract Objective To investigate the clinical behavior of two different resin-based restorative systems in extended Class II cavities in a controlled prospective split-mouth study over 12 years and to assess…
Highlights • Similar primary zirconia properties by speed-sintering as conventional sintering. • Speed-sintering 3Y-TZP decreased its translucency but not that of 5Y-PSZ. • Speed-sintering lowered the mechanical reliability of 3Y-TZP…
Abstract Objective To investigate the clinical behavior of two different resin-based restorative systems in extended Class II cavities in a controlled prospective split-mouth study over 12 years and to assess…
Graphical abstract Highlights • Direct laser metal sintering (DLMS) 3D printing conditions were optimized for medical-grade Ti-6Al-4V powders. • The inner defect amount and mechanical properties varied depending on the…
Abstract Objective Agglomeration is a common problem facing the preparation and application of nanomaterials, and whether nano-hydroxyapatite (nano HA) can modulate oral microecology left to be unclear. In this study,…
Highlights • The composite filaments were successfully developed via melt-blending technique. • AMP-PEEK filaments can serve as feedstock for 3D printing of patient-specific implants. • The bioactivity of the composites…
Highlights • The clinical procedure to adhesively lute ceramic restorations is complex, by which a simplified application procedure is desirable. • Silane-coupling monomers degrade in water; hydrolysis is avoided when…
Abstract Objectives Tetrahydrofurfuryl-methacrylate (THFM) and hydroxypropyl-methacrylate (HPM) were used to partially or fully replace HEMA in experimental RMGICs. The experimental materials were compared with home and commercial products in terms…
Abstract Objective Water sorption, high volumetric shrinkage, polymerization stress, and potential estrogenic effects triggered by leached compounds are some of the major concerns related to BisGMA-TEGDMA co-monomer systems used in…
Abstract Narrow-diameter implants (NDIs) traditionally have been associated to higher rates of failure in comparison with regular-diameter implants (RDIs) and wide-diameter implants (WDIs), since they generate a more unfavorable stress…
Abstract Objectives The purpose of the study was to compare the mvM stresses occurring in inlays, onlays and endocrowns made from different materials and their bonding with molars in a…
Highlights • An increased surface roughness of zirconia reduces cell spreading of osteoblasts. • An increased tetragonal phase ratio of zirconia increases cell viability of osteoblasts. • Wettability is increased…
Abstract Objective To investigate the impact of high-speed sintering, layer thickness and artificial aging in a chewing simulator on the fracture load (FL) and two-body wear (2BW) of 4Y-TZP crowns….
Graphical abstract Abstract Objective This investigation tested pre-shaded 3Y-TZP materials on optical, mechanical and structural properties and calculated correlations between these properties. Methods Seven A2-shaded 3Y-TZP zirconia materials were investigated…
Highlights • Pre-heating does not reduce polymerization stress of resin composite restorations. • Thio-urethane addition increases resin composite degree of conversion. • Thio-urethane addition reduces resin composite polymerization stress. Abstract…
