Introduction Initial cleft severity in patients with complete unilateral cleft lip and palate (UCLP) varies. This is reflected in the sizes of the cleft and the palate. The purpose of…
Suppose for a minute that you have had some trouble with the state board of dentistry in the jurisdiction in which you practice. Maybe it was only 1 or 2…
This case report describes the treatment of a patient with a horizontally impacted maxillary central incisor, a canine in the same quadrant, and an inclusion tendency. Due to severe crowing…
For a girl, aged 12 years 3 months, with a skeletal Class III malocclusion, negative overjet, severe maxillary crowding, and hyperdivergent pattern, orthognathic surgery combined with orthodontic treatment is often…
Introduction This clinical study was performed to evaluate the anteroposterior and vertical displacement patterns of the maxillary teeth in sliding mechanics depending on the position of interradicular miniscrews after the…
Introduction The purpose of this research is to determine the accuracy and reliability of measurements obtained from 3-dimensional (3D) cone-beam computed tomography (CBCT) for different head orientations. Methods Stainless steel…
Introduction The objectives of this research were to assess skeletal and dental changes in patients with Class II malocclusion treated with the edgewise crowned Herbst appliance in the early mixed…
Ingestion of a foreign object, including a dental object, can lead to a trip to the emergency room. This article describes the accidental swallowing of a key that was used…
Introduction This was a cross-sectional study to investigate the agreement between assessments of orthodontic treatment need of the index of complexity, outcome, and need (ICON) and the index of orthodontic…
Introduction The objective of this research was to compare the effect of preactivation on the force system of beta-titanium T-loop springs (TLSs). Methods Twenty TLSs with dimensions of 6 ×…
Introduction This study evaluates the changes in the force system of the beta-titanium T-loop spring (TLS) caused by stress relaxation. Methods Ninety TLSs with dimensions of 6 × 10 mm,…
Introduction For orthodontic applications, equiatomic nickel-titanium (NiTi) wires are used to level and align the teeth under bending conditions in the oral environment for long periods. The aim of study…
Introduction Retention is an important, even critical, component of orthodontic treatment. There is little research on practice protocols and patient compliance with long-term or short-term retention. This lack of information…
Three-dimensional (3D) models of teeth and soft and hard tissues are tessellated surfaces used for diagnosis, treatment planning, appliance fabrication, outcome evaluation, and research. In scientific publications or communications with…
Second molars can create great delays in orthodontic treatment if they are not managed intelligently. The purpose of this article was to describe common torque and position problems of the…
Introduction The cervical vertebrae maturation (CVM) method has been advocated as a predictor of peak mandibular growth. A careful review of the literature showed potential methodologic errors that might influence…
Introduction The aims of this research were to use high-performance liquid chromatography to assess the bisphenol A (BPA) released from an orthodontic adhesive (Transbond XT; 3M Unitek, Monrovia, Calif) with…
Introduction The aim of this study was to evaluate the dentoskeletal and soft-tissue effects of Class II malocclusion treatment with the Jasper jumper followed by Class II elastics at the…
Introduction Rapid palatal expanders (RPEs) have attachments cemented to the teeth and a screw that covers the palate. Because of their position and relative size, RPEs can affect speech. Our…
Introduction An accurate prediction of the mesiodistal diameter (MDD) of the erupting permanent teeth is essential in orthodontic diagnosis and treatment planning during the mixed dentition period. Our objective was…
