Effect of layering methods, composite type, and flowable liner on the polymerization shrinkage stress of light cured composites

Nov 28, 2017 by in Dental Materials Comments Off on Effect of layering methods, composite type, and flowable liner on the polymerization shrinkage stress of light cured composites

Abstract Objectives The aim of this study was to investigate the effect of layering methods, flowable composite liner and use of low shrinkage silorane-based composite on the polymerization shrinkage stress…

read more

The effect of disinfecting solutions on the dimensional stability of dental alginate impression materials

Nov 28, 2017 by in Dental Materials Comments Off on The effect of disinfecting solutions on the dimensional stability of dental alginate impression materials

Abstract Objectives Dimensional changes occur in set dental alginate impression materials when immersed in disinfecting solutions. In this contribution the dimensional changes of two alginates in two disinfecting solutions, and…

read more

Apatite crystal protection against acid-attack beneath resin–dentin interface with four adhesives: TEM and crystallography evidence

Nov 28, 2017 by in Dental Materials Comments Off on Apatite crystal protection against acid-attack beneath resin–dentin interface with four adhesives: TEM and crystallography evidence

Abstract Objectives Interaction between specific functional groups and apatite crystals may contribute to adhesion. The present study investigated effects of four adhesives with different compositions on protection of crystals beneath…

read more

Evaluation of bond strength of resin cements using different general-purpose statistical software packages for two-parameter Weibull statistics

Nov 28, 2017 by in Dental Materials Comments Off on Evaluation of bond strength of resin cements using different general-purpose statistical software packages for two-parameter Weibull statistics

Abstract Objectives This study evaluated and compared Weibull parameters of resin bond strength values using six different general-purpose statistical software packages for two-parameter Weibull distribution. Methods Two-hundred human teeth were…

read more

Response to Dr Kühnisch

Nov 28, 2017 by in Dental Materials Comments Off on Response to Dr Kühnisch

I am writing in reference to the paper, Longevity of materials for pit and fissure sealing—Results from a meta-analysis, by Künisch et al., Dental Materials 2012;28:298–303. The authors suggest two…

read more

Corrigendum to “Differentiation of human mesenchymal stem cells on niobium-doped fluorapatite glass–ceramics” [Dental Materials 28 (3) (2012) 252–260]

Nov 28, 2017 by in Dental Materials Comments Off on Corrigendum to “Differentiation of human mesenchymal stem cells on niobium-doped fluorapatite glass–ceramics” [Dental Materials 28 (3) (2012) 252–260]

The authors wish to inform the readers of a needed clarification in this manuscript regarding the Acknowledgments section of their article. The National Institute of Dental and Craniofacial Research (NIDCR)…

read more

Modeling of ultrathin occlusal veneers

Nov 28, 2017 by in Dental Materials Comments Off on Modeling of ultrathin occlusal veneers

Abstract Objective The purpose of this investigation was to compare stresses within bonded porcelain and composite resin ultra-thin occlusal veneers to restore advanced erosive lesions. Materials and methods A sound…

read more

Imaging in vivosecondary caries and ex vivodental biofilms using cross-polarization optical coherence tomography

Nov 28, 2017 by in Dental Materials Comments Off on Imaging in vivosecondary caries and ex vivodental biofilms using cross-polarization optical coherence tomography

Abstract Objective Conventional diagnostic methods frequently detect only late stage enamel demineralization under composite resin restorations. The objective of this study is to examine the subsurface tooth–composite interface and to…

read more

Some aspects of the formulation of alginate dental impression materials—Setting characteristics and mechanical properties

Nov 28, 2017 by in Dental Materials Comments Off on Some aspects of the formulation of alginate dental impression materials—Setting characteristics and mechanical properties

Abstract Objective To study the role of the various components of alginate dental impression materials. Methods Experimental materials were formulated and their physical properties characterized and compared to commercially available…

read more

The effect of disinfecting solutions on the dimensional stability of dental alginate impression materials

Nov 28, 2017 by in Dental Materials Comments Off on The effect of disinfecting solutions on the dimensional stability of dental alginate impression materials

Abstract Objectives Dimensional changes occur in set dental alginate impression materials when immersed in disinfecting solutions. In this contribution the dimensional changes of two alginates in two disinfecting solutions, and…

read more

Cytokine release from human leukocytes exposed to silorane- and methacrylate-based dental materials

Nov 28, 2017 by in Dental Materials Comments Off on Cytokine release from human leukocytes exposed to silorane- and methacrylate-based dental materials

Abstract Objectives Silorane-based dental monomers contain an epoxy functional group. Less is known about the toxicological and inflammatory potential of silorane-based composites. Therefore we compared the release of 24 cytokines…

read more
Premium Wordpress Themes by UFO Themes