Abstract Objectives To synthesize and characterize machinable, bioactive glass-ceramics (GCs) suitable for dental implant applications. Methods A glass in the SiO 2 –Al 2 O 3 –CaO–CaF 2 –K 2…
Abstract Objective Dental implants provide support for dental crowns and bridges by serving as abutments for the replacement of missing teeth. To prevent bacterial accumulation and growth at the site…
Abstract Objective To assess interfacial fracture toughness of different adhesive approaches and compare to a standard micro-tensile bond-strength (μTBS) test. Methods Chevron-notched beam fracture toughness (CNB) was measured following a…
Abstract Objectives It is proposed that a non-uniform rational B-spline (NURBS) based solid geometric model of a ceramic crown would be a flexible and quick approach to virtually simulate root…
Abstract Objectives Previous studies have shown that resin composites may cause persistent inflammation of oral or pulpal tissues as well as cell death through eluted substances. The aim of this…
Abstract Objectives The majority of modern resin-based oral restorative biomaterials are cured via photopolymerization processes. A variety of light sources are available for this light curing of dental materials, such…
In the natural world we are surrounded by photosynthesis, but probably seldom give this amazing phenomenon any extended thought. So also, dental clinicians and scientists have become so used to…
Abstract Introduction The aim of this study was to evaluate the effect of smear layer removal on the push-out bond strength between radicular dentin and three calcium silicate cements (CSC)…
Abstract Objectives The aim of this in vitro study was to evaluate the influence of substructure design, veneer application technique, and firing regime on the failure and fracture resistance of…
Abstract Objectives MDP (10-methacryloyloxydecyl dihydrogenphosphate) has been proven to possess chemical bonding ability to tooth hard tissues, but its contribution to the enamel bond strength has not been recognized. The…
Abstract Objective Delamination of porcelain from intact zirconia framework was recently reported as the most common failure mode of these restorations. The aim of this study was to investigate the…
Abstract Objectives This in vitro study aimed to evaluate and compare marginal fit of three-unit fixed dental prostheses (FDPs) fabricated using a newly developed direct metal laser sintering (DMLS) system…
Abstract Objectives The occurrence of recurrent caries at the interface of dental materials and the enamel surface is an important performance issue. The objective of this study was to investigate…
Abstract Objectives A validated numerical model for stress/strain predictions is essential in understanding the biomechanical behavior of implant-supported dental prostheses. The digital image correlation (DIC) method for full-field strain measurement…
Abstract Objective Study and evaluation of fracture toughness, flexural and dynamic mechanical properties, and crosslink density of ternary thiol–ene–methacrylate systems and comparison with corresponding conventional methacrylate system were considered in…
Abstract Objective This study examined the in vitro and in vivo response of osteoblasts to a novel, acid-etched and sandblasted zirconia surface. Methods Osteoblastic hFOB 1.19 cells were cultured either…
Abstract Objectives To evaluate the properties of self-adhesive restorative materials used as sealants in comparison with sealants with hydrophobic or hydrophilic monomers. Methods The self-adhesive materials tested were Fusio (FS)…
Abstract Objectives This study aimed at evaluating the therapeutic bioactive effects on the bond strength of three experimental bonding agents containing modified Portland cement-based micro-fillers applied to acid-etched dentin and…
Abstract Objective The aim of this study was to test the hypothesis that monolithic lithium disilicate glass-ceramic occlusal onlay can exhibit a load-bearing capacity that approaches monolithic zirconia, due to…
Abstract This study explored the spatial variations in mechanical behavior of resin-infiltrated dentin using nanoscopic Dynamic Mechanical Analysis (DMA). Objective The objectives were to: (1) evaluate the mechanical behavior of…
