Oral appliance and craniofacial problems of obstructive sleep apnea syndrome

Chapter 11 Oral appliance and craniofacial problems of obstructive sleep apnea syndrome

1 INTRODUCTION

Pierre Robin (1934) used the monoblock mandible advancement appliance for the purpose of treating patients with obstructive sleep apnea for the first time.1 Following this, Boraz treated pediatric OSA patients.2 Cartwright and Samelson (1982)3 reported the effectiveness of the tongue retaining device (TRD) which retains the tongue in the bulb of the device. Meier-Ewert (1984)4 used Esmarch–Heiberg manipulation, which opens the airway of a general anesthetized patient, and developed the Esmarch appliance. The tongue retaining appliance represented by the TRD, and the mandible advancing type represented by the Esmarch, are the two main types of oral appliance. Thereafter, other oral appliances were developed such as the adjustable type, which can adjust the amount of mandible advancement. Currently, more than 55 oral appliances (OAs) are on the market.5

2 PATIENT SELECTION

In 2006, the Standards of Practice Committee of the American Academy of Sleep Medicine published the reports Oral Appliance for Snoring and Obstructive Sleep Apnea: A Review6 and Practice Parameters for the Treatment of Snoring and Obstructive Sleep Apnea with Oral Appliances: An Update for 2005.7 Oral appliances are indicated for use with patients with primary snoring and with mild to moderate OSA, who prefer them to continuous positive airway pressure (CPAP) therapy, or who do not respond to CPAP, are not appropriate candidates for CPAP, or who have failed treatment attempts with CPAP.

3 PROCEDURES FOR ORAL APPLIANCE THERAPY

The procedures for oral appliance therapy are as follows.

4 ORAL APPLIANCE VARIATIONS

With so many different oral appliances available, selection of a specific appliance may appear somewhat difficult, but they are designed around a few major themes. Oral appliances can be classified by mode of action or design variation. Nearly all appliances fall into one of two categories: the tongue retaining type and the mandibular advancing type.

4.2 MANDIBULAR ADVANCING TYPE

The mandibular advancing type functions by repositioning and maintaining the mandible in a protruded position during sleep. This serves to open the airway by indirectly pulling the tongue forward, keeping the soft palate attached to the tongue (oral seal) by the negative pressure occurring in the mouth and making it more rigid. It also holds the lower jaw and other structures in a stable position to prevent opening of the mouth.

4.2.1 NON-TITRATABLE TYPE

The mandibular advancing and non-titratable type of oral appliance is a custom-made monoblock device connected by two separate arches (maxillary and mandibular) without an advancing mechanism. Several versions are listed below.

1. Esmarch appliance (Fig. 11.2A&B). Meier-Ewert developed this mandibular advancing and non-titratable type of oral appliance, using the Esmarch–Heiberg manipulation method, which opens the airway of the general anesthetized patient.
2. Nocturnal airway patency appliance (NAPA) (Fig. 11.3A &B). With this appliance, the mandible is in a protruded position during sleep. This serves to open the airway by indirectly pulling the tongue forward and keeping the soft palate attached to the tongue. This device has a hole in the front extended portion, to enable inhaling from the mouth.
3. Mandibular repositioner (Fig. 11.4A&B). This appliance also has a hole in the front to enable inhaling from the mouth.
4. Snore guard (Fig. 11.5A&B). This appliance is made of heat-activated resin.

4.2.2 TITRATABLE TYPE

The mandibular advancing and titratable type of oral appliance is a custom-made two-piece appliance composed of two separate arches (maxillary and mandibular) containing an advancing mechanism. Examples are listed below.

1. Klearway (Fig. 11.6A&B). This custom-made two-piece appliance is composed of two separate arches (maxillary and mandibular) to advance the mandible with a screw (0.25 mm/1 turn) to determine the ideal forward position of the mandible required to adequately open the airway. A total of 44 forward positions are available in increments of 0.25 mm, which covers a full 11.0 mm range of anterior–posterior movement.
2. Thornton adjustable positioner (TAP) (Fig. 11.7A&B). This appliance is composed of two separate arches (maxillary and mandibular) containing an advancing mechanism and a base and hook assembly with an internal adjustment mechanism.

< div class='tao-gold-member'>

Only gold members can continue reading. Log In or Register to continue

Stay updated, free dental videos. Join our Telegram channel

Jul 24, 2016 | Posted by in General Dentistry | Comments Off on Oral appliance and craniofacial problems of obstructive sleep apnea syndrome

VIDEdental - Online dental courses

Get VIDEdental app for watching clinical videos