8 Introduction, History, and Emergence of Prosthetically Driven Implant Placement

Section 3: Osseous Surgery in Implant Therapy

Chapter 8

Introduction, History, and Emergence of Prosthetically Driven Implant Placement

Steven M. Morgano, DMD

Modern implant dentistry began in North America with the 1982 Toronto Conference on Osseointegration in Clinical Dentistry (Zarb and Schmitt 1991). The implant method used by Zarb and Schmidt was developed by Branemark et al. (1969) in Sweden. Prior to this conference, dental implants had not been well accepted by U.S. prosthodontists because of the relatively high failure rate reported for previous implant designs and techniques (Schnitman and Shulman 1980).

TREATMENT OF THE EDENTULOUS MANDIBLE

In the Toronto study, edentulous patients who could not adapt to well-made complete dentures were treated with mandibular implant-supported, metal-acrylic resin, screw-retained fixed complete dentures. Because these complete dentures were fixed restorations that were made with materials and techniques commonly employed for removable complete dentures, the slang term “hybrid prosthesis” was commonly used to describe these dentures (Academy of Prosthodontics 1987).

These mandibular dentures were designed with long transmucosal abutments that were attached to the implant platforms, raising the inferior border of the prosthesis well above the ridge crest in an attempt to facilitate cleaning (Figure 8.1). However, this design often created a flat shelf on the inferior border of the prosthesis with wide-open spaces that were difficult to clean (Figure 8.2). Five implants were commonly used to retain and support the prosthesis, and these implants were commonly placed by the surgeon freehand (McCartney 1993), without regard to the design of the final prosthesis. The ability to make a complete denture that was rigidly fixed was a revolutionary development in dentistry, and few dentists concerned themselves with precision during implant placement. Because the prosthesis was retained with screws, screw-access channels were placed over the center of each implant. The location of these screw-access channels was dictated by the location and angulation of the implants beneath them, and the openings of the access channels could compromise aesthetics and occlusion (Hebel and Gajjar 1997) (Figure 8.3).

Figure 8.1 Screw-retained fixed complete denture describe by Zarb and Schmidt. (A) Right view; (B) left view. Note the long transmucosal abutments to which the prosthesis is attached.

c08f001

Figure 8.2 Inferior view of prosthesis shown in Figure 8.1. Note shelf-like appearance of this inferior surface that can impede the patient’s access to clean this surface.

c08f002

Figure 8.3 Occlusal view of prosthesis shown in Figure 8.1. Screw-access channels will be filled with composite resin after the prosthesis is screwed in place. Access channel openings have minimal effect on aesthetics and occlusal function; nevertheless, the occlusal surfaces of some of the teeth are compromised.

c08f003

With time, the design of this prosthesis/>

Only gold members can continue reading. Log In or Register to continue

Stay updated, free dental videos. Join our Telegram channel

Jan 14, 2015 | Posted by in Periodontics | Comments Off on 8 Introduction, History, and Emergence of Prosthetically Driven Implant Placement

VIDEdental - Online dental courses

Get VIDEdental app for watching clinical videos