1: Basic Pharmacology and Anatomy: A Whistle-stop Tour

Chapter 1

Basic Pharmacology and Anatomy: A Whistle-stop Tour

Aim

The aim of this chapter is to describe the basic principles of dental local anaesthesia.

Outcome

After reading this chapter you should have a basic understanding of the pharmacology and anatomy of dental local anaesthesia.

Introduction and Terminology

The main purpose of this book is to act as a practical guide to the use of local anaesthesia in dentistry. Before embarking on practical issues it is important to acquire a basic understanding of the pharmacology and anatomy of dental local anaesthesia. Anaesthesia is defined as a loss of sensation in a circumscribed area of the body by a depression of excitation in nerve endings or an inhibition of the conduction process in peripheral nerves. This definition includes all sensation. In dentistry it is pain sensation we want to eliminate. Loss of pain sensation is termed analgesia. The terms local anaesthesia and local analgesia are used almost synonymously in dental practice. As true anaesthesia may be produced on occasion following intra-oral injection, the former term is used in this book.

How is Local Anaesthesia Achieved?

Local anaesthesia may be obtained by a number of mechanisms. Traumatic severance of a nerve will produce it. This may occur after damage to the lingual nerve during third molar surgery. This is not always reversible. In order to be acceptable for clinical use a reversible method is required. Local anaesthetic drugs achieve this goal. Although the mechanism of local anaesthetic action is complex it can be explained in a straightforward way. A nerve transmits information along its length by producing a change in the electrical gradient across the nerve cell membrane (Fig 1-1). At rest the inside of the nerve cell is negatively charged compared to the outside. When the nerve is excited to the so-called “firing” level this polarity changes. The reversal in electrical charge is the signal that is transmitted along the nerve. This change in polarity is principally due to the rapid entry of positively charged sodium ions into the cell. At rest the cell is impermeable to sodium ions. Stimulation causes a conformational change that permits the inward passage of these positive ions. Thus, transmission is dependent upon sodium ion entry. This occurs at the sodium channel. Local anaesthetics work by inhibiting the passage of sodium into the nerve cell. In simple terms they act as chemical roadblocks to the transmission of electrical impulses. They achieve this by a combination of two mechanisms. First, there is probably a contribution to the effect by a non-specific expansion of the nerve cell membrane. This causes physical obstruction of the sodium channel. Secondly, and more importantly, local anaesthetics bind reversibly to specific receptors in the sodium channel. The binding site for the local anaesthetic molecule is exposed during a conformational change that occurs to the sodium channel during the refractory period of the firing cycle. During this period further stimulation of the nerve is ineffective in producing a signal. When the local anaesthetic binds to its receptor the sodium channel is maintained in the refractory conformation. A simplified diagrammatic representation of this action is shown in Fig 1-2.

QE06_Meechan_fig002.jpg

Fig 1-1 The major factor involved in nerve transmission is the differential concentration of sodium ions across the nerve membrane. Local anaesthetics block the entry of sodium into the cell and thus prevent “firing”.

QE06_Meechan_fig003a.jpg

Fig 1-2 At rest, ion passage through the sodium channel is inhibited by a gate known as the “m” (for “make”) gate. This gate is open during “firing”. During the refractory period, another gate, the “h” (for “halt”) gate, closes blocking further sodium entry. The local anaesthetic molecule binds to a receptor on or close to the “h” gate maintaining the channel in the refractory conformation.

Access to the local anaesthetic binding site is obtained from the inside of the nerve cell. This is important and represents an interesting pharmacological challenge. Why? In order to gain entry into the cell the anaesthetic must be soluble in fat, as the cell membrane contains much lipid. Non-charged molecules are fat-soluble. Therefore, to gain entry into the cell the local anaesthetic must be in a non-charged state. As specific binding to a receptor is important in achieving anaesthesia a material that recognises its receptor is needed. Receptor binding depends upon the molecule being charged. Thus, once in the cell, it is important that the molecule is in a charged form. This ability to exist in both lipid-soluble and charged states is achieved because local anaesthetics are weak bases. When the local anaesthetic is in solution some of the molecules are charged and some are uncharged (Fig 1-3). It is only the uncharged molecules that can penetrate the lipid nerve cell membrane to gain access to the inside of the cell. The uncharged portion enters the nerve cell and then re-equilibrates in this aqueous environment to a mixture of charged and uncharged molecules. Once in the cell it is the charged portion that binds to the specific receptor. If no material enters the cell the local anaesthetic will not function. The more rapidly a local anaesthetic enters the cell the more effective it is and the quicker it will act. Thus materials that have a high proportion of uncharged molecules present in tissue fluid after injection are the most effective. Two factors govern the proportion of charged to uncharged molecules following injection. These are:

  • the pH of the region

  • the dissociation constant (pKa) of the local anaesthetic molecule.

QE06_Meechan_fig003b.jpg

Fig 1-3 Local anaesthetics molecules are present in both charged and uncharged forms in solution. It is the uncharged moiety that enters the nerve cell. This then re-equilibrates to charged and uncharged forms and the charged portion binds to the specific receptor to block sodium entry.

The relationship of these factors to the proportion of charged and uncharged molecules in solution is explained in the Henderson Hasselbach equation:

QE06_Meechan_fig004.jpg

Therefore, the lower the pH the less uncharged local anaesthetic molecules are present in solution. The lower the pKa the more uncharged molecules exist. Local anaesthetics vary in their pKas and thus differ in their onset of action. For example, the older dental local anaesthetic procaine had a pKa of 9.0 compared to the pKa of 7.9 for lidocaine. This is one reason why lidocaine is a much more effective local anaesthetic compared to procaine.

Another reason why local anaesthetics va/>

Only gold members can continue reading. Log In or Register to continue

Stay updated, free dental videos. Join our Telegram channel

Jan 3, 2015 | Posted by in Esthetic Dentristry | Comments Off on 1: Basic Pharmacology and Anatomy: A Whistle-stop Tour

VIDEdental - Online dental courses

Get VIDEdental app for watching clinical videos